Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Bathroom Remodeling: The Irvine Owner’s Guide
Belgard bathroom remodeling in Irvine typically runs $9,000-$28,000 for a full renovation, with smaller baths starting around $5,000. We stock Belgard-compatible hardscape and masonry materials for Irvine’s climate, and we quote every project with a flat written price before any work begins. Most Irvine homeowners first notice trouble when grout lines crack after winter rains, or when Belgard pavers in shower floors or accent walls start lifting from the substrate beneath.
Which Belgard Models This Applies To
Belgard does not manufacture bathroom fixtures in the traditional sense. What Irvine homeowners are usually asking about is Belgard hardscape integrated into bathroom design: shower floor pavers, accent wall cladding, wet-room thresholds, and spa-deck transitions. The relevant series are the Ardesie line for slip-resistant shower floors, Quarziti for wall applications, and Outdoor Living components used in indoor-outdoor bath setups common in Orchard Hills and Shady Canyon homes.
To identify your material, check the underside of a loose paver for the stamped Belgard logo and lot code. The Ardesie 2.0 has a 24mm thickness and micro-beveled edge that differs from the original Ardesie’s 20mm straight cut. Mixing series on the same plane creates lippage, which is why we photograph and document every existing surface before quoting replacement. OEM Belgard is sourced through their West Coast distribution in Corona; we also vet aftermarket equivalents from Techo-Bloc when the project budget demands it, but we note the origin on the written quote so you know what you’re getting.
Signs Your Belgard Bathroom Remodeling Is Failing

- Grout cracking along paver joints. Irvine’s hard water and seasonal temperature swings cause efflorescence that weakens standard grout. We see this most in homes near the 133 corridor where groundwater mineral content runs high.
- Pavers sounding hollow when tapped. This means the thin-set or mud bed has delaminated from the substrate. The fix isn’t re-grouting; it’s removal, substrate prep, and reinstallation with the correct modified thin-set for Belgard’s absorption rate.
- Staining that won’t clean with standard stone cleaner. Belgard’s concrete-based products are porous. If sealant has failed, oils and hard water penetrate. In Irvine’s sun-exposed master baths, we see sealant degradation accelerate after about 18 months without reapplication.
- Lippage between adjacent pavers. Often from improper initial installation, but also from subfloor deflection in older Irvine tract homes built on post-tension slabs that weren’t designed for the dead load of a wet-room paver system.
- Efflorescence blooming on the surface. White powder means moisture is migrating through the paver body. In coastal Irvine zones near Newport Back Bay, salt air compounds this. The underlying waterproofing membrane, not the paver itself, is usually the culprit.
Before
AfterReplacement Cost & What’s Included
| Scope | Price Range in Irvine |
|---|---|
| Small bathroom remodel (Belgard hardscape accents) | $5,000-$12,000 |
| Full bathroom remodel with Belgard shower floor/walls | $9,000-$28,000 |
| Walk-in shower installation with Belgard paver base | $4,500-$12,000 |
| Tub-to-shower conversion with hardscape surround | $3,500-$10,000 |
| Belgard paver replacement only (same footprint) | $2,500-$6,500 |
What drives the range: substrate condition, whether the waterproofing membrane passes a flood test, and whether we’re matching discontinued Belgard lots. Under Clause 1 of the Haven Standard, your written quote includes every line item: demolition, substrate prep, materials, labor, and the 365-Day Done Right Promise. No change proceeds without a signed change order. We’ve kept projects within a few percent of the agreed number across 4,000-plus jobs since 2007 by sticking to that discipline.
DIY or Call Us?

There’s safe checking, and then there’s the part where most Irvine homeowners stop. You can verify the Belgard lot code, photograph the failure pattern, and confirm whether your home is still under the builder’s warranty if it’s a newer Orchard Hills or Portola Springs build.
What we don’t recommend: removing Belgard pavers yourself to inspect the membrane. The waterproofing layer beneath is a bonded system; disturbing it without the replacement materials and cure-time knowledge risks turning a $3,000 repair into a $12,000 full gut. Grant Rowan put it this way early on: “Measure twice, build it once, write it down.” That applies double when you’re standing on a concrete slab with a hammer and uncertainty. For a documented assessment with photos you keep, call (657) 227-2502.
FAQs
The material itself is rated for decades, but the sealant and grout need attention every 18-24 months in Irvine’s climate. Coastal salt air and hard water shorten that to 12-18 months. We include a maintenance schedule with every completed job. Call (657) 227-2502 for an exact quote on your specific installation.
Sometimes. If the substrate is sound and the pavers are still well-bonded, we can grind out and re-grout, then reseal. But if the membrane has failed or there’s hollow-sounding delamination, partial repair traps moisture and guarantees a bigger bill later. We test and photograph before recommending either path. Call (657) 227-2502 for a free assessment.
A full remodel with Belgard hardscape runs 3-5 weeks in Irvine, depending on HOA approval timelines and permit inspection scheduling. Paver-only replacement on a sound substrate is typically 3-5 days. We build the schedule into your written quote so you’re not guessing. Call (657) 227-2502 to review the timeline for your project.
We maintain relationships with Belgard’s West Coast distribution and can typically source current-series materials within a week. Discontinued colors or special-order textures may extend that. We confirm availability before you sign, not after. For current stock status on your specific Belgard line, call (657) 227-2502.
Rowan Construction Group Irvine is an independent service provider and is not affiliated with Belgard. We also stock and install materials from KraftMaid, Cambria, and Silestone.
Ready to get a written price before anyone picks up a tool? Call (657) 227-2502 to schedule your free estimate. We’ll bring a documented photo record of what we find, a line-item quote you can screenshot and compare, and the Free Second Opinion on any written estimate you’ve already received.
Written by Grant Rowan, Owner, Rowan Construction Group Irvine at Rowan Construction Group Irvine, serving Irvine and nearby areas.







Before
After
Before
After
Before
After